目前moto编程器软件仅仅支持windows操作系统，其他系统暂不支持；
推荐的计算机配置要求CPU为奔腾100以上，至少有16MB内存，操作系统为 Windows 95 或者更新的版本，诸如 Windows98，ME，NT4，2000，以及 Windows XP 系统。要求的硬盘空间少于 10MB。
并且电脑要有一个空闲的COM端口，一个LPT 并行端口。
Programming of this MCU have to be done in Serial Ram Load Mode.
MCU 必须处在 串行RAM加载模式
For this purpose the following connection have to be make
如此连接，即可置于串行RAM加载模式
RTS Reset
TxD RDI
RxD TDO
适配器和MCU的连接
IRQ connect through 10k to 2xVdd (+10/12V)
TCAP1 to Vdd (+5V) , through a resistor 1k
PD3 to Vdd(+5V), through a resistor 1k
PD4 to Vss , through a resistor 1k
OSC1, OSC2 to quartz resonator 4MHz and capacities to Vdd
Vdd to +5V
MCU 其它引脚连接
Note that when chip protection is activated (SEC bit is 0) connection between UPA and MCU can not be made.
提示：如果MCU已被加密，请不要进行编程操作，防止破坏MCU。
怎样读写68HC08的CPU？
MC68HC908
These microcontrollers have to be in Monitor mode during programming
MCU必须处于监视模式
适配器和MCU的连接RTS Reset
TxD through a diode to PTA0
RxD PTA0
Pullup resistor 10k connected between PTA0 and Vdd
MCU 其它引脚连接
Quartz resonator and capacities to OSC1 and OSC2
PCT1 to GND
PCT0 though a resistor to Vdd
Vdda to Vdd
Vss, Vssa to GND
PCT3 to GND or through a resistor 10k to Vdd
Depend on Baud Rate
PCT3 与GND 连接 - 倍速波特率
PCT3 与Vdd 连接 - 正常波特率
怎样读写68HC11的CPU？
The controller must be in Special bootstrap mode
必须处于 BootStrap 模式
适配器和MCU的连接
RST Reset
TxD PD0/RxD
RxD PD1/TxD
This output is open drain, so a 10k pullup resistor is needed.
MCU 的输出是 开路驱动，必须加入一个上拉电阻
MCU 其它引脚连接
MODA connect to Vss
MODB connect to Vss
XTAL, EXTAL connect to 4/8MHz quartz resonator and capacities
If the security feature was specified and security bit is set EEPROM will be automatically erased.
MOTO 编程器都支持什么芯片型号？